Causes of Rework and cost overuns in construction of sea water Thesis Proposal

Causes of Rework and cost overuns in construction of sea water desalination projects in Kingdom of Saudi Arabia - Thesis Proposal Example Desalination is a very important term, especially for the countries where fresh water resources are scarce. It could be any process that removes a vast amount of salt and other minerals from the water. Habitually, it is known as the procedure of drawing the salts and minerals. It is best to purify your water with the process of desalinated and then use it for drinking and as well as for irrigational activities. This is the same process which is being used by many seagoing ships and sub-marines (Love et. al. 2004). In today’s world, desalination is mainly used for developing cost-effective ways of giving fresh water to such regions of the world where fresh water is in meager amount. If you are intending to do a large scale desalination process then you may also need massively powered infrastructures but it is sure to increase the expense you will pay on the overall project, so it is better to make the usage of fresh water from rivers or wells etc. According to the census performed n April 2010, Saudi Arab had a population of 27,136,977 humans out of which 18,707,576 were recognized as nationals and others were living with no nationality. Due to an overwhelming economic and urban growth of this country, more than 95% of the whole population has been settled down now. Some cities even have densities of more than thousand people per square kilometer. About 50% of the total water used in this country is generated by the process of desalination, whereas the other 40% is extracted from the mining of non-renewable groundwater, the remaining 10% is simply taken off from the surface water. This research will highlight the issues related to desali9nation processes in Saudi Arab which cause cost overruns. Problem Statement: The problem which will be studied in this research is: Causes of Rework and cost overruns in construction of sea water desalination projects in Kingdom of Saudi Arabia. Research Objectives: There are four main objecti ves of this research which are listed below: To study existing sea water desalination projects for cost overruns To explore the reasons of rework and cost overruns in sea water desalination projects To investigate low cost alternatives which can control the cost of sea water desalination projects in Saudi Arabia To find ways of avoiding this cost overruns if construction of sea water desalination projects in Kingdom of Saudi Arabia Research Scope and limitation: This research will study 2 cases where cost overrun has been reported in construction of sea water desalination projects in Saudi Arab. Due to the constraint of time and budget, it is not possible to study the whole universe in this research. However, the case study selection will be based on the criteria that the projects which represent and can highlight the problems of all existing desalination projects should be chosen. This research is limited in the sense that not every existing sea water desalination project will be s tudied under it. Also, it is not possible for the researcher to study every aspect of the problem under discussion, so this research is limited to study of aspects of cost overrun. Methodology: For any research, qualitative or quantitative, primary or secondary, the most important part is its methodology. Methodology sets the stage for all further work to be done in any research (Gauch, 2002). Research can be done successfully and the objectives can be achieved if the research methodology laid out to conduct this research is properly planned. As research methodology is what leads any research towards its success, its importance can never be undermined in case of any research (Symon, et. al., 2000). This research is focused basically on primary data collection. A lot of tests and experiments have been conducted to get the required